|
We manufacture 3 types of Rugged Chargers, 12 Volt, 6 Volt and
5 Watt.
These controllers are pre-set to charge lead acid or gel cell batteries
with constant voltage regulation to customer voltage. They can run
electronics directly without a battery. They do not interfere with
radio reception/transmission. They do not use power unless input
is on. Designed for harsh environments and long life. |
|
RC-12, 12 Volt Rugged Series Chargers |
|  Tough
chargers for harsh environments.
Used in the trucking industry to charge refrigeration unit batteries
by using extra power from truck lighting wire harness.
Extends the battery life and ensures the batteries are ready for
use at all times.
- Caution - Reversing input polarity will damage charger
- Constant Voltage Regulation - Will protect the output
from high voltages if output batteries are removed temporarily
- Over Temperature Protection - Shuts down if too hot
- Turns On With Input - Does not use power unless input
is on
- Built In Blocking Diode - Prevents battery drain back
to input
|
| Specifications: |
| Battery Power Consumption: |
Zero. |
| Status Lights: |
None |
| Output Voltage: |
Constant Voltage Regulation
(Set-point to user requirements) |
| Temperature Range: |
–40C to +50C (-40F to +120F) |
| Typical Output Current: |
1 Amp |
| Case: |
Solid Aluminum Case, completely
sealed in epoxy. |
| Size: |
5.1 x 5.1 x 3.8 cm (4.75
x 3 x 1-1/8” inches) |
| Weight: |
325 Grams |
| Mounting: |
Wall Mountable |
| Wire Leads: |
Oil Resistant 16 AWG |
|
|
|
 6
Volt Battery Charger / Load Controller Tracking System Charger |
 Boomerang
Charger
Tough, easy to install battery charger and battery protection for
18 wheeler tracking systems. This charger starts charging a 6 volt
battery when the input turns on. Designed to take power from a wiring
harness and charge a 6 volt battery whenever power is available. The
charger limits the input current to a maximum of 1 Amp, 0.5 Amps typical.
The charger shuts down completely when the harness turns off. A very
low power circuit continuously monitors the battery voltage to protect
the battery from excessive discharge, this increases battery life
and prevents the battery from freezing. |
| Features |
- Unique - Very Low Battery consumption
- Protection (Input), against short-circuit & reverse
polarity, overload
- Protection (Batt), against short-circuit, overload, over
temperature & battery removal
- Protection (Load), against short-circuit, overload, over
temperature
- Can charge a completely discharged battery
- Constant voltage and current limited output
- Reliable - 100% solid state
- No radio interference • Silent
- Solid aluminum case
- 5 year warranty
- Manufactured with solar power
- Designed and built in North America
|
|
| Specifications: |
| Electrical
Specifications |
| Voltage Configuration |
6 Volts (Custom Voltages
Available) |
| Max. Input voltage |
15 Volts |
| Max. Charging Current |
0.5 Amps DC |
| Battery Consumption |
Less Than 1 mA with Input
Off |
| Wire Leads: |
18 Gauge Wire Leads |
| Typical Set Points: |
Load On 5.8 Volts Rising Load Off: 5.5
Volts Descending |
| General
Specifications |
| Temperature Range: |
–40°C to +85°C (-40°F to
+185°F) |
| Case: |
Solid Aluminum Case |
| Weight: |
310 Grams |
| Size:(H x W x D) |
7.6 x 17.6 x 2.6 cm (3 x
7 by 1 inches) |
| Mounting: |
Wall Mountable with Two 3/16
holes |
| Features
& Options |
| Regulation method current
limited constant voltage type |
| Built in blocking diode |
| Custom
voltage setpoints |
|
|
| |
| RC-6, 6 Volt Rugged Series Chargers |
 This
controller is pre-set to charge lead acid or gel cell batteries.
Can run electronics directly without a battery.
Designed for harsh environments and long life.
Current limited to 0.5 Amps
- Reverse Polarity Protection - Both input and output
- Efficient Design - Never uses any battery power - no
waste
- No EMI - Does not interfere with radio reception/transmission
- Constant Voltage Regulation - Can run electronics directly
without a battery on the output and protects the output from high
voltages if output batteries are removed temporarily
- Built In Blocking Diode - Prevents battery drain back
to input
|
| Specifications: |
| Battery Power Consumption: |
Zero. |
| Status Lights: |
None |
| Output Voltage: |
Constant Voltage Regulation
(Set-point to user requirements) |
| Temperature Range: |
–40C to +40C (-40F to +105F) |
| Typical Output Current: |
0.5 Amp |
| Case: |
Solid Aluminum Case, completely
sealed in epoxy. |
| Size: |
5.1 x 5.1 x 3.8 cm (4.75
x 3 x 1-1/8” inches) |
| Weight: |
325 Grams |
| Mounting: |
Wall Mountable |
| Wire Leads: |
Oil Resistant 16 AWG |
|
|
|
| 5
Watt PV Charge Controller |
|  Designed
specifically to work with the Unisolar 5 PV module.
You can run electronics directly from the sun with this controller,
a battery is not required, for example you could run a 12 or 6 volt
transistor radio without batteries with this controller directly
from Watt PV module.
A unique and highly efficient design means that it never uses any
battery power to run the charger. No wasted power.
Other chargers can be on all the time wasting power at night and
slowly draining the battery.
- Reverse Polarity Protection - Both input and output
- Efficient Design - Never uses any battery power - no
waste
- No EMI - Does not interfere with radio reception/transmission
- Constant Voltage Regulation - Can run electronics directly
without a battery on the output and protects the output from high
voltages if output batteries are removed temporarily
- Built In Blocking Diode - Prevents battery drain back
to input
|
| Specifications: |
| Battery Power Consumption: |
Zero. |
| Status Lights: |
None |
| Output Voltage: |
Constant Voltage Regulation
|
| Temperature Range: |
–40C to +40C (-40F to +105F) |
| Typical Output Current: |
0.3 Amp |
| Case: |
ABS Case, completely sealed
in epoxy. |
| Size: |
5.1 x 5.1 x 3.8 cm (4.75
x 3 x 1-1/8” inches) |
| Weight: |
125 Grams |
| Mounting: |
Wall Mountable |
| Wire Leads: |
16 AWG |
| Models: |
RC-5W6 (6 Volt) RC-5W (12 Volt) |
|
|
| For custom design and applications of all our products
for your needs please contact us. |
|
